Has anything slipped?

Why this exists

A part that was never built and a part that broke are two different problems with two different fixes. Guessing between them wastes days.

1. 1

   Every reply gets kept

   When you paste your builder's reply back into the Workshop, we read the report block and save each line as a pass or a fail against that app.

2. 2

   Slips get flagged

   If a line passed at least once and is failing now, we call that a slip. It sits at the top of the list, in red.

3. 3

   Flip-flops get flagged too

   A line that keeps changing its mind is usually a shaky bit of work rather than bad luck. We mark those as wobbly.

How to use it

1. 1

   Open the card

   It sits on Repair Bay and on My app, above everything else.

   Open Repair Bay
2. 2

   Press Fix the slips

   We write one prompt that names only the lines that broke, and tells your builder not to touch anything else.

3. 3

   Paste the reply back

   Same loop as always. The card updates itself, so you never tick a box by hand.